Service manual

Chapter 2
2-14
F-2-47
13) Affix the two supplied harness covers (bases) at the right rear of the machine with it aligned with the bottom line of the reader.
F-2-48
14) Affix the supplied harness cover (base) [1] at the back of the machine with it aligned with the bottom line of the reader.
F-2-49
15) Connect the connector of the repeating harness B [1] to the connector J317 [2] on the image processor PCB.
F-2-50
16) Using the supplied binding screw (M4x6) [1], secure the repeating harness B clamp [2].
[1]
[2]
[1]
[1]
[2]
[1]