Service manual

Chapter 2
2-19
F-2-61
2.5.3 Installing the Heater PCB
0011-3365
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Install the heater PCB unit [2] using the two supplied TP screws (M3x8) [1].
2) Install the heater switch [3] on the right side panel.
Install the heater switch with the OFF position on the left and the ON position on the right just like the main power switch.
F-2-62
3) Install the edge saddle (large) [1] and connect one heater switch harness [2] to the connector (J1901) on the heater PCB. Route the other harness [3] to the front
of the host machine through the saddle.