Service manual

Chapter 2
2-20
F-2-63
4) Install the edge saddle (small) [1] on the power supply unit at the front of the host machine, and then connect the header switch harness [2] (routed to the front
of the host machine) to the connector (J15) on the power supply PCB through the edge saddle.
F-2-64
5) Install the four clamps [1] on the back of the host machine.
6) Connect the cassette heater harness [2] to the connector (J1905) on the heater PCB unit, install the reuse band [3], and then pass the harness through the clamps
installed in step 5).
F-2-65
7) Install the edge saddle (small) [1].
8) Connect the heater harness [2] to the connector (J1902) on the heater PCB unit, pass the harness through the installed edge saddle, and then route the harness to
the front of the host machine through the hole [3].