Service manual

Chapter 2
2-21
F-2-66
9) Pass the heater harness [1] through the wire saddle [2], and then connect it to the connector (J17) [3] on the power supply PCB.
F-2-67
10) Install the delivery tray. (2 screws)
When reinstalling the delivery tray, be careful not to damage the paper holder.
11) Attach the upper-right cover of the host machine. (1 screw)
12) Attach the lower-right cover of the host machine. (5 screws)
13) Attach the rear cover of the host machine. (4 screws)
14) Close the front cover of the host machine.