User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How to Use This Manual
- Legal Notices
- Basic Copying Features
- Special Copying Features
- Customizing Settings
- Copy Settings Table
- Specifying Copy Settings
- Image Direction Priority
- Auto Orientation
- Standard Image Quality
- Standard Density
- Standard Zoom Ratio
- Standard Copy Quantity
- Auto Collate
- Standard Two-Sided Copying
- Standard Frame Erase
- Standard Two-Page Separation
- Paper Drawer Selection
- Sharpness
- Paper Size Group
- Frame Erase Width Unit of Measurement
- Restoring the Default Copy Settings
- Appendix
Flow of Copy Operations
1-4
Basic Copying Features
1
Flow of Copy Operations
This section describes the flow of basic copy operations.
NOTE
•
For the following items, see the Reference Guide:
- Main power and control panel power switch
- Routine maintenance
•
Output quality may deteriorate if the platen glass is dirty. Always keep the platen glass
clean.
•
Do not touch the feeder or platen cover while copying. Rocking the feeder or cover can
distort the image being copied.
1
Place your original face-up in the feeder (when attached) or
face-down on the platen glass.
NOTE
For details about placing the originals, see “Placing Originals,” on p. 1-10.
● If the message <ENTER DEPT.ID> appears:
❑
Enter the Department ID and Password.
NOTE
For instructions on using Department ID Management, see Chapter 6, “System
Manager Settings,” in the Reference Guide.
ENTER DEPT.ID