Setup guide

Setting Specifications That Are Common to Each Function (Common Settings)
3-22
3-223-22
3-22
3
33
3
Selecting and Storing Settings to Suit your Needs
NOTE
•
••
•
Prints of the Mail Box and Report modes are output as “Other.”
•
••
•
In the case that the Saddle Finisher-G1 is not attached, Tray C can only be assigned to a single
function, which no other tray is assigned to.
•
••
•
When the Saddle Finisher-G1 is attached, the print is output to Tray B, regardless of the dedicated
tray setting if transparency, envelope, heavyweight paper, tracing paper, or free size paper is
selected.
•
••
•
When the Saddle Finisher -G1 is attached, the print is output to Tray A regardless of the dedicated
tray setting if the Staple mode is set.
•
••
•
When the Inner 2way Tray-A1 is attached, the print is output to Tray A regardless of the dedicated
tray setting, if Transparency, Envelope, Heavyweight paper, Tracing paper, or Free size paper is
selected.
3
33
3
Press “Done.”
Press “Done.”Press “Done.”
Press “Done.”
Repeat this procedure.
The specified mode is set and the display returns to the Basic Features screen.
Setting the Printing Priority
Setting the Printing PrioritySetting the Printing Priority
Setting the Printing Priority
You can set the printing priority. A job that is set to a high priority is printed preferentially after the
job currently being processed.
NOTE
•
••
•
Priority printing will not take place even when you set the highest priority, until the current job is
completed. However, if the current job is paused, printing of the job from a function with higher
priority may start, depending on the settings.
•
••
•
The default settings are as follows:
- Copy: 1 (Priority)
- Printer: 2
- Other: 3 (1, 2, and 3 indicate priority sequence.)
1
11
1
Call up the desired screen as follows:
Call up the desired screen as follows:Call up the desired screen as follows:
Call up the desired screen as follows: