Setup guide

Periodic Inspection of the Breaker
xxv
xxvxxv
xxv
2
22
2
Make sure that the breaker lever automatically goes to the OFF position
Make sure that the breaker lever automatically goes to the OFF position Make sure that the breaker lever automatically goes to the OFF position
Make sure that the breaker lever automatically goes to the OFF position
(“ ” side), and confirm that the power is cut OFF.
(“ ” side), and confirm that the power is cut OFF.(“ ” side), and confirm that the power is cut OFF.
(“ ” side), and confirm that the power is cut OFF.
IMPORTANT
•
••
•
Do not use the test button to turn the power ON and OFF.
•
••
•
If the breaker lever does not go to the OFF position (“ ” side) repeat step 1.
•
••
•
If the breaker lever does not go to the OFF position (“ ” side) despite carrying out the above procedure two or
three times, contact your service representative.
•
••
•
The breaker lever may stop between ON and OFF, depending on the type of breaker.
•
••
•
When the breaker lever is stopped between ON and OFF, it is in an OFF state.
3
33
3
Once the step above is completed and confirmed, turn the main power
Once the step above is completed and confirmed, turn the main power Once the step above is completed and confirmed, turn the main power
Once the step above is completed and confirmed, turn the main power
switch OFF (
switch OFF (switch OFF (
switch OFF ( side).
side).side).
side).
ON
(“I
II
I” side)
OFF
(“ ” side)
ON
(“I
II
I” side)
OFF
(“ ” side)
ON
(“I
II
I” side)
OFF
(“ ” side)