Setup guide

Main Power and Control Panel Power
1-25
1-251-25
1-25
1
11
1
Before You Start Using This Machine
The screen below is displayed until the machine is ready to scan.
The screen below is displayed when the machine is ready to scan.
The machine is ready to print after about 29 seconds (at a room temperature of 20°C).
IMPORTANT
•
••
•
If you turn off the main power, wait at least three seconds before turning the main power back on.
•
••
•
Do not turn the power off if the FAX Board is attached. Transmission/Receive of fax cannot be done
when the power is turned off.
NOTE
•
••
•
In the case above, the Standard settings are selected.
•
••
•
The standard copy settings are as follows:
- Copy ratio: 1:1 (100%)
- Paper selection: Auto Paper Selection
- Copy exposure: Auto Exposure Control
- Copy quantity: 1
- Copy function: 1
→
1-sided copy
•
••
•
You can change the standard copy settings. (See the Copying Guide.)
•
••
•
You can choose which functions to display in the Basic Features screen when turning on the main
power according to the Additional Functions settings. (See ‘Selecting the Initial Function at Power
ON,’ on p. 3-8.)