Operation Manual

4
Setting the Department ID Management
4-10
System Manager Settings
10 Press “Done.”
Repeat this procedure.
When the screen below appears, enter the Department ID and Password.
NOTE
• For details of how to enter the Department ID and Password, see ‘Entering the Department ID
and Password,’ on p. 1-36.
Changing the Password and Impression Limit
The following instructions describe how to change the Password and Impression Limit you
have stored.
1 Call up the desired screen as follows:
When the System Manager ID/Password is set, enter the System Manager ID and System
Password after pressing “System Settings.” Then, press (ID).
2 Press “On,” and press “Store Dept. ID/Password.”
(Additional Functions)
E1L_US_U_.book-INDEX Page 10 Wednesday, May 23, 2001 11:40 PM