Operation Manual

1
Placing Originals
1-40
Before You Start Using This Machine
Orientation of Originals
You can place original either vertically or horizontally. Always align the top edge of your
original with the back edge of the platen glass (top left corner) or the feeder.
NOTE
• If the top edge of the original is not aligned with the back edge of the platen glass, prints may not
be made correctly, depending on the mode you have set.
• LTR and STMT-size originals can be placed either vertically or horizontally. However, the scanning
speed for horizontally placed originals is somewhat slower than for vertically placed originals. You
can place originals horizontally when printing with Preset Zoom mode, such as when processing
LTR → 11" x 17".
• Horizontally placed LTR and STMT-size originals are referred to as LTRR and STMTR.
• 11" x 17" and LGL-size originals must be placed horizontally.
Place the original
face down
Place the original
face down
ABC
ABC
Place the original
face up
Place the original
face up
[Platen glass]
[Feeder]
Horizontal placementVertical placement
Horizontal placementVertical placement
E1L_US_U_.book-INDEX Page 40 Wednesday, May 23, 2001 11:40 PM