Setup guide

Erasing Shadows and Frame Lines from Copies (Frame Erase)
2-28
2-282-28
2-28
2
22
2
4
44
4
Select the desired original frame erase width using [–] or [+], and press [OK]
Select the desired original frame erase width using [–] or [+], and press [OK] Select the desired original frame erase width using [–] or [+], and press [OK]
Select the desired original frame erase width using [–] or [+], and press [OK]
→
press
press press
press
[Done].
[Done].[Done].
[Done].
When entering values in millimetres, you can use - (numeric keys) and .
Even when you enter the values with - (numeric keys), you can change the values with [–] or [+].
The value set here is specified for all sides around the original. To set independent frame erase width
values for the top, bottom, left, and right sides of the original, press [Adjust Each Dim].
When you select [Adjust Each Dim.], select the side of the frame erase width using [–] or [+], and press
[OK] → press [Done].
The specified mode is set and the display returns to the Basic Features screen.
If you enter a value outside the setting range, a message prompting you to enter the appropriate value
appears in the screen.
NOTE
•
••
•
If you want to enter values in inches, then press [Inch]. Set the inch entry function to [On] in the Additional Functions
beforehand. (See the Reference Guide.)
•
••
•
The default setting is 4mm.