Setup guide

Erasing Shadows and Frame Lines from Copies (Frame Erase)
2-30
2-302-30
2-30
2
22
2
4
44
4
Press each key: [Top], [Left], [Center], [Right], and [Bottom]
Press each key: [Top], [Left], [Center], [Right], and [Bottom] Press each key: [Top], [Left], [Center], [Right], and [Bottom]
Press each key: [Top], [Left], [Center], [Right], and [Bottom]
→
set the desired book
set the desired book set the desired book
set the desired book
frame erase width using [–] or [+]
frame erase width using [–] or [+] frame erase width using [–] or [+]
frame erase width using [–] or [+]
→
press [OK]
press [OK] press [OK]
press [OK]
→
[Done].
[Done].[Done].
[Done].
When entering values in millimetres, you can use - (numeric keys) and .
Even when you enter the values with - (numeric keys), you can change the values using [–] or [+].
The values set here are specified independently for all sides around the original. To set the same value for
all sides around the original, press [Adjust All At Once].
When you select [Adjust All At Once], enter the value using [–] or [+], and press [OK].
The specified mode is set and the display returns to the Basic Features screen.
If you enter a value outside the setting range, a message prompting you to enter an appropriate value
appears in the screen.
NOTE
•
••
•
If you want to enter values in inches, then press [Inch]. Set the inch entry function to [On] in the Additional Functions
beforehand. (See the Reference Guide.)
•
••
•
The default settings are 10mm for [Center] and 4mm for [Top], [Left], [Right] and [Bottom].
•
••
•
If you select [Adjust Each Dim.], then you want to set a value uniformly around the original, press [Adjust All At Once].