Setup guide

Erasing Shadows and Frame Lines from Copies (Frame Erase)
2-32
2-322-32
2-32
2
22
2
The position of the binding holes refers not to the position in which the original is placed on the platen
glass, but to the position of the binding holes viewed when the surface of the original that you want to
scan is face up, with its top edge aligned with the top left corner of the platen glass.
4
44
4
Set the desired binding erase width using [–] or [+], and press [OK]
Set the desired binding erase width using [–] or [+], and press [OK] Set the desired binding erase width using [–] or [+], and press [OK]
Set the desired binding erase width using [–] or [+], and press [OK] → press [Done].
press [Done]. press [Done].
press [Done].
When entering values in millimetres, you can use - (numeric keys) and .
Even when you enter the values with - (numeric keys), you can change the values using [–] or [+].
The specified mode is set and the display returns to the Basic Features screen.
If you enter a value outside the setting range, a message prompting you to enter an appropriate value
appears in the screen.
NOTE
•
••
•
If you want to enter values in inches, press [Inch]. Set the inch entry function to [On] in the Additional Functions
beforehand. (See the Reference Guide.)
•
••
•
The default setting is 18mm.
5
55
5
Press .
Press . Press .
Press .
Copying starts.
NOTE
•
••
•
To cancel the setting, press [Special Features]
→
[Frame Erase]
→
[Cancel], in this order.
•
••
•
To cancel all settings and return the machine to the Standard mode, press .