Color Network Printer Expansion Kit-C1 Installation Procedure Follow the instructions described below to install the Color Network Printer Expansion Kit-C1 to copier.
Follow the instructions described below to install the Color Network Printer Expansion Kit-C1 to copier. [1] PDL boot ROM ............................................ 1 pc. [4] Setup guide .................................................. 1 pc. [2] User software CD-ROM ............................... 1 pc. [3] Color N/W ScanGear CD-ROM .................... 1 pc. [5] User Manual CD-ROM ................................. 1 pc.
2) Remove the 7 screws [1], and detach the rear cover [2]. [1] Before starting the work, be sure to perform the following on the host machine in the order indicated: 1. Turn off the control panel power switch. 2. Turn off the main power switch. 3. Disconnect the power cable (from [1] [1] the wall/floor outlet). [2] [2] OFF [1] OFF ON/OFF 3) Remove the 12 screws [1], and detach the controller box cover [2].
) Push the slot lever [1], and detach the boot ROM [2]. 3) Press [network settings]. 4) As necessary, check and set the following: [TCP/IP settings], [NetWare settings] (indicated for a NetWare model), [AppleTalk settings], and the like. [1] For details, see the User Manual (Net[2] Memo work Guide). • From the user software CD-ROM, install the printer driver to the PC. 1) Execute ‘setup’ or ‘add printer’.
ecute color adjustment. • If you have connected the reader unit, execute ‘auto gradation correction using the host machine’s service mode (COPIER>ADJUST>PASCAL). • If the machine is a printer model, connect the CC100, and execute calibration (user operation).
PUB.
