USER MANUAL
CONTENTS SAFETY INFORMATION P3-5 Read Before Use Maintaining The Device Waterproof Cautions OVERVIEW P6 Supplied Items Product Features GETTING STARTED P7-11 Charging Inserting/Removing MicroSD Card Power ON/OFF First Time Pairing With Your Mobile Device Camera Default Settings OPERATIONS P12-13 Wireless Mode Photo Mode Video Mode Multi Mode LED INDICATIONS P14 ACCESSORY P15 TROUBLESHOOTING P16 SPECIFICATIONS P17 2
SAFETY INFORMATION READ BEFORE USE Please read the following instructions and safety precautions before using the device. For regulatory and additional safety information, refer to the Safety Precautions and Warranty Information leaflet included in your package contents. RMN: PG1001 Regulatory Model Identification Number is assigned for regulatory identification purpose. WARNING Used to indicate a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION Used to indicate the level of a hazard or damage which, if product is handled erroneously, may result in injury or property damage other than product faults. • Electromagnetic interference or electrostatic discharge may cause the device to malfunction or the MicroSD card memory to be lost or altered. Should this occur, use a pin with a blunt end to press the Reset Button at the rear of the device for more than 10 seconds.
MAINTAINING THE DEVICE • Please charge the device at the recommended temperature of 15º to 32ºC. • Use and keep the device in the recommended environment of 15º to 32ºC. Avoid using or storing the device in humid or dusty places. • After the device is exposed to dirty water, rinse it with fresh water and dry it completely with a soft cloth. • The device is shockproof to 2 m (6.6 ft.). However, strong impacts could cause physical damage to the device and cause it to malfunction.
OVERVIEW SUPPLIED ITEMS Outdoor Camera Basic Setup Safety Precautions and Warranty Information USB Cable PRODUCT FEATURES 2 4 3 5 1 6 11 9 8 10 13 14 7 12 16 15 Camera Lens Mode LED Detachable Faceplate Status LED Side Cover MicroSD Card Slot (up to 256GB) Latch Release Button Micro USB Port Strap Hole Shutter Button Tripod Screw Hole Microphone Clip Speaker Reset Button ON/OFF/Mode Dial Switch *To reset all parameters to default setting, turn on the device, then use a pin with
GETTING STARTED CHARGING MODE LED Charging: Red Fully Charged: Green Press on the latch release button, and slide the side cover upward to open it. Insert the smaller end of the supplied USB cable into the device and the other end into a chargeable USB adapter. The Mode LED will turn red to indicate charging. Once fully charged, the Mode LED will turn green. -- Operating time may vary depending on the battery status, operational status and environment conditions.
INSERTING/REMOVING MicroSD CARD INSERT AND REMOVE THE MicroSD CARD • Press on the latch release button and slide the side cover upward to open it. • Insert the MicroSD card into the MicroSD card slot hidden by the side cover. You will feel a slight click when the card is fully inserted. • Push on the top of the MicroSD card to release it. Gently pull it out to fully remove it from the device.
An external MicroSD card (up to 256 GB) is needed for saving captured photos and videos. Only FAT16, FAT32 and exFAT formats are supported. Class 10 or above is recommended for a satisfying user experience. Use the following memory cards (sold separately) • MicroSD memory cards *1 • MicroSDHC memory cards *1 *2 • MicroSDXC memory cards *1 *2 Cards conforming to SD standards. However, not all memory cards have been verified to work with the camera. *1 UHS-I memory cards are also supported.
POWER ON/OFF • Turn the Mode Dial from to any other mode, the device will turn on in around 4 seconds. • Turn the Mode Dial to to turn off the device. AUTO POWER OFF The device will power off automatically when idle for 3 minutes (default). • The user can resume the device by pressing the Shutter Button or turning the Mode Dial to any mode. • The user can change the time (3 minutes/5 minutes/10 minutes) in the app.
CAMERA DEFAULT SETTINGS Your camera has the following default settings and options.
OPERATIONS WIRELESS MODE Connect your device to a Mobile Device for the operations below: • Remote shooting photo/video • Live View for photo/video capture • Access DCIM folders stored in the MicroSD Card, including being able to "View", "Delete", "Edit", or "Download the photo/video to Mobile Device" from the MicroSD card. PHOTO MODE • Press the Shutter Button to capture a photo. • Press and hold the Shutter Button to shoot continuously.
MULTI MODE You can either capture photos or record videos using different shutter operations. PHOTO • Press the Shutter Button once to capture a photo. • Continuous photo recording is not available in Multi Mode. VIDEO • Press and hold the Shutter Button for more than 4 seconds to start video recording. • Keep holding the Shutter Button to record video. • Video recording will stop once you release the Shutter Button. The maximum video length is 10 minutes.
LED INDICATIONS Status LED Mode LED Status Powered On & Standby (Photo/Video/Multi/ Wireless Modes) Powered Off/ Auto-Power off Mode LED Status LED Green Off Low Battery Red (Blinking rapidly) Charging Red Fully charged Green Bluetooth® pairing Green > Red (Looping) Wi-Fi connected Green Photo captured and saved Red (Blink once) Video recording Red (Blinking slowly) Mass Storage mode Green Data transferring under Mass Storage mode Green (Blinking rapidly) Firmware upgrading Green (Blinking
ACCESSORY DETACHABLE FACEPLATE The device has a detachable faceplate. Gently lift up the detachable faceplate to remove it. Customize the device by changing the faceplate. * Additional faceplates are sold separately.
TROUBLESHOOTING When the Status LED is blinking red rapidly, it may be related to one of the following reasons. Error Device does not work Actions • Make sure the battery level is not too low. If it is, recharge the device • Press the reset button for 10s to restart if the device is unresponsive • Make sure if the MicroSD card is inserted without card error • Make sure the firmware is up-to-date or successfully upgraded.
SPECIFICATIONS Photo Resolution 13MP Video Resolution 1080p 60fps 1080p 30fps 720p 30fps (supports Live View recording) Video Format MPEG-4 Zoom Fixed Focal Length (35mm film equivalent) 25.4 mm Aperture f/2.
If the device is not functioning properly, please contact the dealer you purchased this product from or Canon Service & Support at www.canon-europe.