User Manual

Basic Operating Procedure
Basic operating procedure
Note: For details on how to turn on the power of the lens,
refer to the camera
’
s Operation Manual.
[ I-Gain ] [Trk]
OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
DISPLAY
DISPLAY
DISPLAY
Push the DISPLAY switch.
The display lights up.
The display is turned off.
The changes made are stored in the memory.
Turn on the power of the lens.
Push the DISPLAY switch.
Use the control key to perform the settings.
1
2
3
4
[ I-Gain ] [Trk] OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
Details of how to set the setting items are given on page
E2-2 and following.
Checkpoint: If the control key is not operated for 2 or more
minutes, the display turns off automatically. (Auto
OFF)
However, while the Fol. screen is shown, the
display will not turn off automatically no matter
how many minutes elapse. It is turned off only
by pushing the DISPLAY switch.
Checkpoint: Even when the display is turned off by AUTO
OFF, the changes made to the settings are
stored in the memory just as when the display is
turned off by pushing the DISPLAY switch.
Note: The changes made to the setting will be stored in
the memory and turned off by pushing the DISPLAY
switch while the display is shown .
Note: In the case of the power of the lens turned off while
the display is shown, the changes made to the setting
may not be stored in the memory.
E12
To restore the original settings
The initial factory settings can be restored at times
when, for instance, settings have been performed
incorrectly or as a trial.
For details, see Resetting on page E3-6.
IMPORTANT
ResetAll
User
User:
AllUser:
1
y/n
y/n
Reference: Display that appears when the
settings are to be reset