User Manual

E2-4
2.2 Users
2.2 Users
[ ]
User 1 to 9
Detailed settings can be performed for each user who will be performing operations. The settings estab-
lished can be saved.
The number of users for whom these settings can be performed is 9. (User 1 to 9)
User 0
This is the default user for whom the settings can be changed and used on a temporary basis.
The settings cannot be saved.The settings are released when switching to User 1 to 9 or User A (analog
mode) or when the power is turned off. When the escape operation is performed,
User 0 is set. For details on the escape operation, refer to page E3-26. When User 0 is selected, the
factory settings (except for the auto iris gain value, remote iris gain value, F-Hold setting, encoder output
setting, Initialize operation setting and Adjustment of Camera Fol Voltage) are established.
User A (analog mode)
This is selected when a conventional type of drive unit (with analog specifications) is to be operated.
When the analog mode is established, the digital functions can no longer be used. The following applies
to the drive units when this mode has been set.
● The VTR, RET, IRIS A/M and IRIS INST switches perform the functions that correspond to the lettering
inscribed on them. The rocker switch serves as a regular zooming switch.
● The AUX1, AUX2 and MEMO switches cannot be used.
● The auto iris gain adjustment can be set by operating the display or the trimmer control.
● The shuttle shot, frame preset, speed preset and zoom track functions cannot be used.
For details on the analog mode, refer to page E2-6 to E2-11.