User Manual

E2-6

2.2 Users Analog mode settings (User A)

Analog mode settings (User A)

[ ]

User A (analog mode)

This is selected when a conventional type of drive unit (with analog speciﬁcations) is to be operated.

When the analog mode is established, the digital functions can no longer be used. The following applies

to the drive units when this mode has been set.

● The VTR, RET, IRIS A/M and IRIS INST switches perform the functions that correspond to the lettering

inscribed on them. The rocker switch serves as a regular zooming switch.

● The AUX1, AUX2 and MEMO switches cannot be used.

● The auto iris gain adjustment can be set by operating the display or the trimmer control.

● The shuttle shot, frame preset, speed preset and zoom track functions cannot be used.

The displays in the analog mode appear as shown below.

Two types of operations can be performed on the display: the auto iris gain can be adjusted, and the analog mode can

be changed to another user. If the lock mode is established, it must be released (Unlock) before these operations can

be performed. The password used at the setting stage is required to release the lock mode.

Concerning the password

This model does not have a special password setting screen. The password which is established every

time a lock operation is performed is the password which is needed to unlock the function. This means that

you should make a note of each password. If you have forgotten the password, contact Canon or one of its

distributors. Anything from blanks to a maximum of 8 digits can be input as the password.

※

(NOTE):

Unlocked Locked

[ ]

I G : 5 0

[ ]

Lock