User Manual

E2-13
2.3 Iris gain setting -Remote iris gain setting
(2) Remote iris gain setting
Note: When adjusting the gain while
checking the iris operation
-> Check that the A/M switch
on the drive unit is set to the
[AUTO] mode.
-> Set the camera's iris mode to
[Remote].
The remote iris gain has already been set to the appropriate level at the factory but it can be changed if
so desired.
The same remote iris gain setting is used for all the users regardless of the user who is indicated on the
display. For this reason, there is no need to select the user before performing the setting. As an excep-
tion to the general rule, any change made in the setting is reflected for user 0 as well.
The item is now highlighted.
[ I-Gain ] [Trk] OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
2 ޓPush the key.
Set
5 ޓPush the key.
Set
4 ޓMove the key or key.
The display is switched to the [I-Gain] screen.
An underline appears below [Remote].
The last setting or default value is highlighted.
The display returns to Screen A.
Move the left or right key until the value to be
changed to appears.
Top initial screen
㨇I-Gain㨉UETGGP
3 ޓMove the key twice.
1 ޓMove the key.
[ I-Gain ]
Iris
Remote: 90
Auto: 48
[ ]
[ I-Gain ]
Iris
Remote: 90
Auto: 48
[ ]
[ I-Gain ]
Iris
Remote: 80
Auto: 48
[ ]
[ I-Gain ] [Trk]
OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
5ETGGP#
Default value: 90
Set
or
01 㨪Selection item
Function
99
Minimum gain Maximum gain
MENU
Set
×2
[ I-Gain ]
Note: The iris gain setting will not be
reset even when the "Reset-
ting" procedure described on
page 3-6 is initiated. Since
the user can no longer refer
to the factory setting once this
setting has been changed, it is
recommended that the factory
setting be noted down if it will
be required.
[ I-Gain ]
TOP SCREEN