User Manual

E2-26
2.12 Zoom curve mode setting - Seesaw switch curve characteristics setting
(1) Seesaw switch curve characteristics setting
This item makes it possible to change the zoom speed characteristics which is established in response to
the amount by which the zoom seesaw switch is pushed in.
(Bear in mind that the display is switched to another screen when these characteristics are set.)
2 ޓPush the key.
4 ޓMove the key or key.
The display is switched to the CurveMode screen.
An underline appears below [Seesaw].
The last setting or default value is highlighted.
The display returns to Screen A
.
The item is now highlighted.
3 ޓMove the key.
5 ޓPush the key.
Move the left or right key until the number to be
changed to appears.
[ I-Tq ] H
[ Frm1 ] [ Frm2 ]
[ ]
MENU
1
Norm
AM
[ Z.M. ]
[ I-Gain ] [Trk] OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
Zoom
Set
Set
CurveMode
Zoom
Demand:
Seesaw:
5
5
[ ]
CurveMode
Zoom
Demand:
Seesaw:
[ ]
D5
5
CurveMode
Zoom
Demand:
Seesaw:
[ ]
3
5
Screen A
Top initial screen
CurveMode screen
1ޓMove the key five times and the key once.
D㧦Default value
[ Z.M. ] MENU
Set Set
or
5
1 Selection item 2 3 4 D5 6 7 8 9
(1)
(9)
Zoom speed
MAX
Amount by which zoom seesaw switch is pushed in
Zoom direction
Wide angle Telephoto
Amount of change resulting
from zoom mode adjustment
2.12 Zoom curve mode setting
[ Z.M. ]
Prior to operation, select the user for whom the settings will be made.
(For details on how to select the user, refer to page E2-5 or E3-4.)
IMPORTANT