User Manual

E3-10
3.2 User Screen - Copying data between lenses
With the drive unit installed the information display, the setting establisbed on the information display can
be copied into another information display drive unit.There are two copy types.1:Copying the data settings
established for one user (See this page). 2:Copying the data settings established for all the users (See the
page E3-12).A dedicated cable purchased separately is required for this operation. For further details,consult
a Canon sales representative or your Canon dealer.
(1) Copying the data settings established for one user into another lens
3ޓPush the key.
Continued on next page
[ I-Gain ] [Trk]
OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
ToOtherLens
User
Connect:
1
y/n
ToOtherLens
User
Connect:
1
y/n
ToOtherLens
User
Connect:
1
y/n
1ޓPush the key.
Set
2ޓ
Move the key five times.
4ޓMove the key.
Set
Set
An underline appears below [Connect],
and either {y} (YES) or {n} (NO) can now been selected.
5ޓMove the key, and select {y}.
No. :
User
1
Name:
ResetAll
1
The display is switched to the User screen.
The display is switched to the ToOtherLens screen.
Top initial screen
User screen
Screen A
ResetAll
User
Copy
ToOtherLens
1
Screen B
ToOtherLens screen
An underline appears below
[ToOtherLens].
ToOtherLens
User
UserCopy :
AllCopy :
1
y/n
y/n
6ޓPush the key.
The display is switched to the Screen B.
7ޓMove the key.
The operating steps taken be-
tween steps 1 to 12 (within the
two dotted parallel lines) can be
undone without copying the set-
tings. To return to the original
screen, move the up key. To turn
off the display without copying
the settings, push the DISPLAY
switch.
Preparations prior to operation (Be absolutely sure to undertake these preparations.)
1.Plug one end of the dedicated cable (20P-20P) into the zoom remote & focus remote connector (20-pin) of
the copy source lens and the other end into the corresponding connector of the copy destination lens.
2.Turn on the power of the copy source lens and copy destination lens.
3. Push the DISPLAY switch on the copy source lens to turn on the display. (Do not turn on the display of the
copy destination lens.)
Copying data between lenses
Prior to operation, select the user for whom the settings will
be made.
(For details on how to select the user, refer to page E2-5 or E3-4.)
IMPORTANT