User Manual

E3-11
3.2 User Screen - Copying data between lenses
Set
Set
MENU
Set
Set
User
1
Set
5
or
Continued from
Previous page
8ޓPush the key.
ToOtherLens
User
To No. :
Copy:
1
1
y/n
User screen
Copy selection screen
The display is switched to the Copy Selection screen.
The display is switched to the User screen.
10ޓMove the or key.
ToOtherLens
User
To No. :
Copy:
1
y/n
1
ToOtherLens
User
To No. :
Copy:
1
y/n
3
Move the left or right key until the number of the user,
to whom the settings are to be copied, at the copy
destination lens appears.
11ޓMove the key.
9ޓ
Move the key.
An underline appears below [To No.].
An underline appears below [Copy], and either {y} (YES) or
{n} (NO) can now been selected.
Set
13ޓ
Push the key.
12ޓMove the key, and select {y}.
Now Data Copy
Please Wait...
The screen now shows the "Now Data Copy"
message for a few moments before returning
to Screen A
.
This completes the copying of the settings
between the lenses.
ResetAll
User
Copy
ToOtherLens
1
Screen A
Set
ToOtherLens
User
To No. :
Copy:
1
y/n
3
ToOtherLens
User
To No. :
Copy:
1
y/n
3
㧖2
㧖1
ToOtherLens
User
UserCopy :
AllCopy :
1
y/n
y/n
*1: If the Set key is pushed here,
copying is actually com-
menced. Bear in mind that
once copying starts, it will not
be possible to restore the data
in the copy destination lens to
the original data.
*2: Refrain from operating the op-
eration switch or pushing the
DISPLAY switch on either the
copy source lens or copy des-
tination lens while the settings
are being copied. Otherwise,
the copying operation may not
be conducted properly.
Note: If the settings were not copied successfully, an error message will appear.
For details on what remedial action to take, refer to "(3) When an error
display has appeared" on page E3-14.
MENU SCREEN