User Manual

E3-12
3.2 User Screen - Copying data between lenses
(2) Copying the data settings established for all the users into another lens
A dedicated cable purchased separately is required for this operation. For further details, consult a Canon
sales representative or your dealer.
3ޓPush the key.
[ I-Gain ] [Trk]
OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
ResetAll
User
Copy
ToOtherLens
1
ToOtherLens
User
Connect:
1
y/n
ToOtherLens
User
Connect:
1
y/n
ToOtherLens
User
Connect:
1
y/n
Continued on next page
1ޓ Push the key.
Set
2 ޓ Move the key five times.
Set
4 ޓ Move the key.
Set
An underline appears below [Connect],
and either {y} (YES) or {n} (NO)
can now been selected.
No. :
User
1
Name:
ResetAll
1
The display is switched to the User screen.
The display is switched to the ToOtherLens screen.
Top initial screen
User screen
Screen A
An underline appears below [ToOtherLens].
ToOtherLens screen
5ޓMove the key, and select {y}.
6ޓPush the key.
The operating steps taken be-
tween steps 1 to 10 (within the
two dotted parallel lines) can be
undone without copying the set-
tings. To return to the original
screen, move the up key. To turn
off the display without copying
the settings, push the DISPLAY
switch.
Preparations prior to operation
1. Plug one end of the dedicated cable (20P-20P) into the zoom remote & focus remote connector (20-pin)
of the copy source lens and the other end into the corresponding connector of the copy destination lens.
2. Turn on the power of the copy source lens and copy destination lens.
3. Push the DISPLAY switch on the copy source lens to turn on the display. (Do not turn on the display of
the copy destination lens.)