User Manual

E3-13
3.2 User Screen - Copying data between lenses
Set
An underline appears below [AllCopy],
and either {y} (YES) or {n} (NO) can now been selected.
Screen B
y/n
Continued from
Previous page
9
ޓ
Move the key.
ToOtherLens
User
ToAllUser
Copy:
1
y/n
AllCopy screen
The display is switched to the AllCopy screen.
An underline appears below [Copy], and either {y} (YES)
or {n} (NO) can now been selected.
Set
11ޓ Push the key.
10ޓ Move the key, and select {y}.
Now Data Copy
Please Wait...
The screen now shows the "Now Data Copy"
message for a few moments before returning
to Screen A.
This completes the copying of the settings
between the lenses.
ResetAll
User
Copy
ToOtherLens
1
Screen A
The display is switched to the Screen B.
7ޓ Move the key twice.
ToOtherLens
User
ToAllUser
Copy:
1
y/n
ToOtherLens
User
ToAllUser
Copy:
1
y/n
㧖2
㧖1
8ޓ Push the key.
ToOtherLens
User
UserCopy :
AllCopy :
1
y/n
y/n
ToOtherLens
User
UserCopy :
AllCopy :
1
y/n
Set
Set
MENU
Set
User
1
Set
Set
5
2
*1: If the Set key is pushed here,
copying is actually com-
menced. Bear in mind that
once copying starts, it will not
be possible to restore the data
in the copy destination lens to
the original data.
*2: Refrain from operating the op-
eration switch or pushing the
DISPLAY switch on either the
copy source lens or copy des-
tination lens while the settings
are being copied. Otherwise,
the copying operation may not
be conducted properly.
Note: If the settings were not copied successfully, an error message will appear.
For details on what remedial action to take, refer to “(3) When an error dis-
play has appeared” on page E3-14.
MENU SCREEN