User Manual

E3-14
3.2 User Screen - Copying data between lenses
(3) When an error display has appeared
If the settings were not copied successfully between the lenses, refer to the information in the table below.
Lens Connect
Error!!
Has the dedicated
cable (20P-20P) been
connected?
Data cannot be copied between the lenses
unless the dedicated cable (20P-20P)
has been connected.
I
f, during copying, the cable was disconnected
or the power of the copy destination lens
dropped or it was turned off, the screen with
the message shown on the left will be
displayed.
In a case like this, data copying has been
stopped before it was completed and, as a
result, the data is not copied properly.
Data cannot be copied between the lenses
unless the power of both the copy source
lens and copy destination lens has been
turned on.
Has the power of the copy
destination lens been
turned on?
Have the power of both
the copy source lens and
copy destination lens been
turned on?
Has the dedicated
cable (20P-20P) been
connected?
Turn on the power of both the copy source
lens and copy destination lens, and go
through the copying procedure again from
the start.
Check that the power of both the copy
source lens and copy destination lens have
been turned on and the dedicated cable has
been connected securely. Then push the
DISPLAY sw and the display is switched to
the Screen A, and go through the copying
procedure again from the start.
Securely connect the dedicated
cable (20P-20P) to the copy source lens
and copy destination lens, and go through
the copying procedure again from the start.
CheckpointError screen Cause of error
Remedial action
Copy Error!!
User
Copy
ToOtherLens
1
Screen A
Access:
Unlock