User Manual

E3-19
3.2 User Screen - Analog mode settings (User A)
User A (analog mode)
This is selected when a conventional type of drive unit (with analog specications) is to be operated.
When the analog mode is established, the digital functions can no longer be used. The following applies
to the drive units when this mode has been set.
● The VTR, RET, IRIS A/M and IRIS INST switches perform the functions that correspond to the lettering
inscribed on them. The rocker switch serves as a regular zooming switch.
● The AUX1, AUX2 and MEMO switches cannot be used.
● The auto iris gain adjustment can be set by operating the display or the trimmer control.
● The shuttle shot, frame preset, speed preset and zoom track functions cannot be used.
The displays in the analog mode appear as shown below.
Unlocked Locked
[ ]
A
I G : 5 0
I G : 5 0
[ ]
Lock
Two types of operations can be performed on the display: the auto iris gain can be adjusted, and the analog mode
can be changed to another user. If the lock mode is established, it must be released (Unlock) before these opera-
tions can be performed. The password used at the setting stage is required to release the lock mode.
Analog mode settings (User A)
Top
MENU SCREEN
Concerning the password
This model does not have a special password setting screen. The password which is established every time
a lock operation is performed is the password which is needed to unlock the function. This means that you
should make a note of each password. If you have forgotten the password, contact Canon or one of its distribu-
tors. Anything from blanks to a maximum of 8 digits can be input as the password.
※
(NOTE)