User Manual

1 ޓHold down the DISPLAY switch and key for more than 2 seconds.
The following message is displayed depending on the user who was using
the system prior to the jump operation.
User 0 : User 0 Reset Now
User 1 to 9 : Escape To User 0
Set
2 ޓThe Top initial screen is displayed.
User 0
Reset Now
With User 0
Escape To User 0
With User 1 to 9
Any screen
Top initial screen
or
[ I-Gain ] [Trk] OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
[ I-Gain ] [Trk] OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
0
2 sec
Set
and
DISPLAY
[ ]
When the power is turned on again:
The same user who was using the system prior to the jump operation is selected. However, if the user was
changed after the jump operation was performed, the user using the system after the change was made is
selected instead.
This operation makes it possible to jump instantly to the User 0 setting status (factory setting status) from the
current setting status whether for any user (User 0 to 9) or User A.
(1) For User 0 to 9
(2) For User A (Analog mode)
1 ޓHold down the DISPLAY switch and key for more than 2 seconds.
Set
2 ޓThe Top initial screen is displayed.
Escape To User 0
Analog mode
Top initial screen
[ I-Gain ] [Trk] OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
0
[ ]
A
I G : 5 0
3.2 User Screen - Escape operation
E3-26
Escape operation
Even when the jump operation is performed, the settings of the following items will remain the same as before
the jump operation: auto iris gain value, remote iris gain value, F-Hold setting, encoder output setting, Initialize
operation setting and Adjustment of Camera Fol Voltage.
※
(NOTE)
The jump operation cannot be performed in the lock status.
※
(NOTE)