User Manual

E3-47
3.5 Iris Screen - Remote iris gain setting
The display is switched to the Iris screen.
Top initial screen
Iris screen
[I-Gain] screen
6ޓ Push the key.
[ I-Gain ] [Trk]
OFF
Shtl VTR
A 1
FRM1
A 2
V
RET
R
[ ]
MENU
1
1ޓ Push the key, and move the key
three times.
4ޓ Move the key twice.
Set
3ޓ Push the key.
Set
Set
The display returns to Screen A.
52
5ޓ Move the key or key.
[ I-Gain ]
Iris
Remote: 90
Auto: 52
[ ]
[ I-Gain ]
Iris
Remote: 93
Auto: 52
[ ]
An underline appears below [Remote].
The function set last or default value is highlighted.
Move the left or right key until the value to be
changed to appears.
The display is switched to the [I-Gain] screen
.
2ޓ Move the key.
An underline appears below [I-Gain].
Iris
[ ]
[ I-Gain ]
Torque: High
Comp: ON
[ I-Gain ]
Iris
Remote: 90
Auto: 52
[ ]
Screen A
[ I-Gain ]
Iris
Comp: ON
Torque: High
[ ]
or
Set Set
2
3
2
Set
MENU
Default value㧦90
01 㨪Selection item
Function
99
Minimum gain Maximum gain
Iris
[ ]
(2) Remote iris gain setting
The remote iris gain has already been set to the appropriate level at the factory but it can be changed if so
desired.
The same remote iris gain setting is used for all the users regardless of the user who is indicated on the
display. For this reason, there is no need to select the user before performing the setting. As an exception
to the general rule, any change made in the setting is reflected for user 0 as well.
Note: When adjusting the gain while
checking the iris operation
-> Check that the A/M switch
on the drive unit is set to the
[AUTO] mode.
-> Set the camera's iris mode to
[Remote].
Note: The iris gain setting will not be
reset even when the "Reset-
ting" procedure described on
page E3-6 is initiated. Since
the user can no longer refer
to the factory setting once this
setting has been changed, it is
recommended that the factory
setting be noted down if it will
be required.
MENU SCREEN