User Manual

E3-49
3.5 Iris Screen - Setting the iris correction to ON or OFF
Setting the iris correction to ON or OFF
The display is switched to the Iris screen.
Top initial screen
Iris screen
[ -Gain ] [Trk] OFF
A 1
A 2
V
[ ]
MENU
1
Shtl VTR
FRM1 RET
R
㸨㸸This appears when ON
is selected as the
[Comp] setting.
㸨
1
ࠉPush the key, and move the key three times.
3ࠉMove the key or key.
Set
2ࠉMove the key three times.
An underline appears below [Comp].
The function set last or default function is highlighted.
Move the left or right key to select {ON} or {OFF}.
Iris
[ ]
[ I-Gain ]
Torque: High
Comp: ON
Iris
[ ]
Comp:
Close: OFF
Torque: High
ON
Iris
[ ]
Comp:
Torque: High
OFF
ONSelection item
Function
OFF
Iris correction No iris correction
Set
2
3
3
(D)㧦Default value
(D)
or
MENU
Iris
[ ]
The light quantity drops when the extender (2.0x) is used. To compensate for this, a function for correcting
the iris by opening it by an amount equivalent to 2F can be set.
Note: The iris may not close completely when the iris correction function is set to ON and the extender (2.0x) is
used. If this is the case, follow the procedure for
“
Setting the iris close detection to ON or OFF
”
, and set
the detection to ON.
MENU SCREEN
Prior to operation, select the user for whom the settings will be made.
(For details on how to select the user, refer to page E2-5 or E3-4.)
IMPORTANT