User Manual
E3-57
3.6 Zoom Screen - Setting the curve characteristics of the seesaw switch
CurveMode screen
3ࠉPush the key.
4ࠉMove the key.
6ࠉPush the key.
[ I-Gain ] [Trk]
OFF
A 1
A 2
V
R
[ ]
MENU
1
CurveMode
Zoom
Demand:
Seesaw:
[ ]
5
5
Shtl
VTR
FRM1 RET
5ࠉMove the key or key.
The display is switched to the Zoom screen.
Screen A
The display is switched to the CurveMode screen.
The display returns to Screen A
.
Zoom screen
Top initial screen
1
ࠉPush the key, and move the key four times.
Set
Set
Set
2ࠉMove the key four times.
Movement
CurveMode
SpeedAdj
Zoom
[ ]
OFF
Move the left or right key until the
function to be changed to appears.
An underline appears below [CurveMode].
CurveMode
Zoom
Demand:
Seesaw:
[ ]
5
CurveMode
Zoom
Demand:
Seesaw:
[ ]
5
The function set last or default function
is highlighted.
D5
7
Tracking:
F-Hold: OFF
OFF
Movement
Zoom
[ ]
or
D㧦Default value
1
Selection item
2 3 4 D5 6 7 8 9
Set SetSet
2
4
4
MENU
Zoom
[ ]
The characteristics of the zoom speed can be varied in response to the amount by which zoom seesaw
switch is pushed in.
(Bear in mind that the display is switched to another screen when these characteristics are set.)
(1)
(9)
Zoom speed
MAX
Amount by which zoom seesaw switch is pushed in
Zoom direction
Wide angle Telephoto
Amount of change resulting
from zoom mode adjustment
Setting the curve characteristics of the seesaw switch
Top
MENU SCREEN
Prior to operation, select the user for whom the settings will
be made.
(For details on how to select the user, refer to page E2-5 or E3-4.)
IMPORTANT