User`s manual

T460/461/T462 Manual 26th Sept 2008. V2.79 Part B © JED Microprocessors Pty Ltd 16
Fujitsu projectors: LPF4200/4700/5200/6200
Suggested T460 Channel Command sent Connector Function on screen
Channel 1 !PRM08<0Dh> RGB1 Video
Channel 2 !PRM09<0Dh> RGB2 S-Video
Channel 3 !PRM05<0Dh> Video Computer 1
Channel 4 !PRM0D<0Dh> S-Video DVI
Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs in the above table.
RS232 connections to Fujitsu projectors
These use a 9-pin-D9 male on the projector, female on cable.
Function/Direction T460 Connection Fujitsu Port Connector
Ground Ground 9-pin D-sub pin 5
Data from T460 to projector Tx 9-pin D-sub pin 3 (RXD)
Reply data from projector to T460 Rx 9-pin D-sub pin 2 (TXD)
Plus 9 volt CTS/DTR to projector N/C Link pins 7 & 8 (RTS/CTS)
8
1 2 3 4 5
6 7 9
D-sub 9 female
solder side
After installation wiring of any projector to a T460, use a multimeter to check voltages of –9 on BOTH TX and RX pins in any
installation, as described in the troubleshooting part of this manual.
Hewlett-Packard: vp6110/6111/6120/6121
The following table shows the mapping of T460 channel number, the string sent, and the input associated with that channel in
the manual, and how it is identified on the on-screen menu: (Comms is at 19200 8N1) Reply mode, Mute/Freeze supported.
T460 Channel TX code, byte 17 Input name in manual and on screen
1 00h PC source
2 01h YPbPr
3 04h VIDEO
4 03h S-VIDEO
Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs.
RS232 connections to Hewlett-Packard vp61xx family projectors
Function/ Direction T460 “projector”
Connection
HP RS232 port
Connector 8-pin mini-DIN
Ground Ground Pin 8
Data from T460 to projector Tx Pin 7
Reply data from projector to T460 Rx Pin 3
Plus 9 volt CTS/DTR N/C N/C
Mini-DIN 8
solder side
43 5
1 2
6 7 8
After installation wiring of any projector to a T460, use a multimeter to check voltages of –9 on BOTH TX and RX pins in any
installation, as described in the troubleshooting part of this manual. CTS is NOT needed.