User`s manual

T460/461/T462 Manual 26th Sept 2008. V2.79 Part B © JED Microprocessors Pty Ltd

InFocus models: LP225, LP400/425/435, LP720/725/730/735, LP740 (not LP740b)

T460 Channel TX code Input name in manual Function as identified on screen

1 (SRC0) Computer Computer

2 (SRC1) Video Video

3 (SRC2) S-Video S-Video (LP740 only, not LP740b)

Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs.

Some projectors in this range have an auto-source-select. THIS MUST BE DISABLED.

InFocus models: LP340/350

T460 Channel TX code Input name in manual Function as identified on screen

1 (SRC0) Computer 1 Analog Computer 1 Analog

2 (SRC1) Computer 1 Digital Computer 1 Digital

3 (SRC2) Computer 2 Computer 2

4 (SRC3) Video Video

Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs.

Some projectors in this range have an auto-source-select. THIS MUST BE DISABLED.

“Computer 1 Analog” and “Computer 1 Digital” use a “CableWizard” cable plugged into the M1-DA connector and connects

to “Computer 1 Analog” (210-085-xx) or “Computer 1 Digital” (SP-DVI-D).

The CableWizard 2 (SP-CW2) is used for RS232 connection.

(What the “Computer 2” input on these models is, is a bit of a mystery! We can find no trace of a connector on the projector

connection diagram for it in the manual, but it is in the on-screen menu and the programming manual as a valid selection.

Manuals can be downloaded from http://www.infocus.com )

InFocus models: LP500/520/530/Toshiba TDP-S3/T3

(with “Enhanced Connectivity Module”)

T460 Channel TX code Input name in manual Function as identified on screen

1 (SRC0) Computer 1 Analog PC 1 Analog

2 (SRC1) Computer 1 Digital PC 1 Digital

3 (SRC2) Computer 2 PC 2 VESA-VGA (Via E. C. Module)

4 (SRC3) Video – Component Video 1 (Via E. C. Module)

5 (SRC4) S-Video Video 2

6 (SRC5) Video - Composite Video 3

Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs.

The Enhanced Connectivity Module (HW-ECM) must be used as this is the only means of connecting to the cable

mounted D9 RS232 connector. It also provides additional inputs as shown above.

Some projectors in this range have an auto-source-select. THIS MUST BE DISABLED.