User`s manual

T460/461/T462 Manual 26th Sept 2008. V2.79 Part B © JED Microprocessors Pty Ltd 57
TEAC Plasma: PLMSDM1060, PLMHDM1065/1275
The following table shows the mapping of T460 channel number, the string sent, and the input associated with that channel in
the manual, and how it is identified on the on-screen menu:
T460 Channel TX codes Input name in manual Function as identified on screen
1 91h 01h AV1 Composite Video 1
2 91h 02h AV2 S-Video Video 2
3 91h 03h AV3 Video 3
4 91h 04h Component 1
5 91h 05h Component 2
6 91h 06h RGB 9-pin D-sub (Analog) PC Analog
7 91h 07h DV1 PC Digital
Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs.
RS232 connections to TEAC Plasma with D9
These use a 9-pin-D9 male on the plasma, female on cable. Comms is at 9600 baud, 8 bits, no parity, 1 stop.
Function/Direction T460 “projector” Connection “Serial” Port Connector
Ground Ground 9-pin D-sub pin 5
Data from T460 to projector Tx 9-pin D-sub pin 3 (RXD)
Reply data from projector to T460 Rx 9-pin D-sub pin 2 (TXD)
Plus 9 volt CTS/DTR to projector “RTS” N/C
After installation wiring of any projector to a T460, use a multimeter to check voltages of –9 on BOTH TX and RX pins in any
installation, as described in the troubleshooting part of this manual.