User`s manual

T460/461/T462 Manual 26th Sept 2008. V2.79 Part B © JED Microprocessors Pty Ltd 7
Christie projectors: DS30, PLUS-25, PLUS-26, MATRIX-1500
Projection Design: Action! (etc), eCinema (etc), evo (etc), F1 (etc), F2 (etc) and F3 (etc)
Communication is at 19200 8N1
T460 Channel 17
th
byte of 32-byte message Connector / function
Channel 1 00h VGA 1
Channel 2 01h VGA 2
Channel 3 02h DVI
Channel 4 03h Video Component
Channel 5 04h S-Video
Channel 6 05h Video Composite
Channel 7 06h Video Component HD
Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs in the above table.
RS232 connections to Christie DS30, DS+25, Matrix 1500
To connect the T460 to these projectors use a DB9 male on the cable:
Function/Direction T460 “projector”
Connection
Projector Connector
(Male on cable)
Ground Ground 9-pin D-sub pin 5
Data from T460 to projector Tx 9-pin D-sub pin 3 (RXD)
Reply data from projector to T460 Rx 9-pin D-sub pin 2 (TXD)
Plus 9 volt CTS/DTR to projector N/C N/C
3
D-sub 9 male
solder side
4 25 1
9 8 7 6
After installation wiring of any projector to a T460, use a multimeter to check voltages of –9 on BOTH TX and RX pins in any
installation, as described in the troubleshooting part of this manual.
DELL projectors: 2300MP, 2400MP, 4100MP, 5100MP
T460 Channel 12
th
byte of 12-byte message Connector / function
Channel 1 19h D-sub 15 VGA Analog
Channel 2 1Ch M1 Analog (Looks like DVI) (Not 2300/2400MP)
Channel 3 23h Video Composite on RCA single
Channel 4 22h S-Video
Channel 5 20h 3 x RCA Component YPbPr (Not 2300/2400MP)
Channel 6 1Ah D-sub 15 VGA Component YpbPr (Not 2400MP)
Channel 7 51h 5 x BNC RGB Analog (Not 2300/2400/4100MP)
Channel 8 52h 5 x BNC Component YPbPr (Not 2300/2400/4100MP)
Don’t forget to set all unused T460 channels to “Skip” to jump over blank/unused inputs in the above table.
Note: These models have only a “Toggle” function for the “Picture Mute” command, and the “Freeze” function does NOT
work via RS232 (EVEN THOUGH IT’S IN THE BOOK!). So only use Vol Up/Dn or Mute On/Mute Off keyboards. The
yellow buttons both send “toggle state” commands to the projector, but the T460 LCD does NOT show “Mute” status, as there
are no RS232commands to read the state back from the projector, or command a predetermined state.