User Manual

IJ Scan Utility Error Messages
If an error message for IJ Scan Utility appears, check the error code and follow the corresponding solution.
Error Code Error Message Solution
152 There is not enough memory. Exit other applications to increase
available memory.
• The memory required to
start IJ Scan Utility cannot
be obtained; exit other appli-
cations.
153 The image you attempted to scan is in a size that cannot be
opened in the specified application. Change the settings so that
the image size is reduced.
• Reduce the resolution or
output size and scan again.
201 A required file is missing or corrupted, or settings are incorrect.
Try the installation again.
• Delete MP Drivers, then re-
install MP Drivers from the
Setup CD-ROM or our web-
site.
For how to delete MP Driv-
ers, see
Deleting the Unnec-
essary MP Drivers.
202 An internal error has occurred. Take the following measures.
- Check the scanner status.
- Restart the scanner.
- Restart the computer, then try again.
- Reinstall the scanner driver.
• An internal error has occur-
red. Take the following
measures.
◦
Check the scanner sta-
tus.
◦
Restart the scanner.
◦
Restart the computer,
then try again.
◦
Reinstall MP Drivers.
230 A scanner driver supporting this software is not installed. Install it
and try again.
• Reinstall MP Drivers from
the Setup CD-ROM or our
website.
231 Cannot complete the scan. The disk space is insufficient. • Delete unnecessary files on
the hard disk and scan
again.
232 Cannot save the file. The disk is write-protected.
Cancel the protection or use another disk.
• Cancel the write protection
on the disk.
234 This scan function is not supported by the selected model. Se-
lect a different scan function.
• Select a different scan func-
tion.
242 Cannot write file. • Check the access permis-
sion on the folder in Folder
to Save Temporary Files in
the Settings (General Set-
tings) dialog box or Save in
1169