Operation Manual

0L40-051
Connecting to a Network
When connecting the machine to a wired or wireless local area network (LAN), you need to set an IP address unique to the selected
network. Select "wired" or "wireless" depending on your communication environment and networking devices. For steps to connect the
machine and set an IP address, see "Getting Started" (
Manuals Included with the Machine). For specific IP address settings, contact
your Internet service provider or Network Administrator.
If the machine is connected to an unsecured network, your personal information might be leaked to a third party.
The machine cannot connect to both wired and wireless LANs at the same time.
The machine does not come with a LAN cable or router. Have them ready as necessary.
For more information about your networking devices, see the instruction manuals for the devices or contact your
manufacturer.
Before You Start
Follow these steps to connect the machine to a network.
Check your computer settings.
Make sure that the computer is correctly connected to the network. For more information, see the instruction
manuals for the devices you are using, or contact the device manufacturers.
Make sure that the network settings have been completed on the computer. If the network has not been set
up properly, you will not be able to use the machine on the network, even if you perform the rest of the
procedure below.
Depending on the network, you may need to change settings for the communication method (half-
duplex/full-duplex) or the Ethernet type (10BASE-T/100BASE-TX) (
Configuring Ethernet Settings).
For more information, contact your Internet service provider or Network Administrator.
To check the MAC address of the machine, see
Viewing the MAC Address.
Select wired or wireless LAN.
Selecting Wired LAN or Wireless LAN
Connect to a wired or wireless LAN.
Proceed to the section that corresponds to the setting you selected in step 2.
Connecting to a Wired LAN
Connecting to a Wireless LAN
㻝㻠㻢㻌㻛㻌㻟㻟㻢