Operation Manual

Table Of Contents

0L40-057

Setting Up Connection by Selecting a Wireless Router

You can search the wireless routers (or access points) available for connection and select one from the display of the machine. For the

network key, enter a WEP key or TKIP. Before selecting a wireless router, check and write down the required setup information, including

the SSID and network key (

Checking the SSID and Network Key).

Security settings

If the wireless connection is set up by selecting a wireless router, the WEP authentication method is set to <Open System> or

the WPA/WPA2 encryption method is set to <Auto> (AES-CCMP or TKIP). If you want to select <Shared Key> for WEP

authentication or <AES-CCMP> for WPA/WPA2 encryption, you need to set up the connection using the manual entry method

(

Setting Up Connection by Specifying Detailed Settings).

Press .

Use / to select <Network Settings>, and press .

If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and press . Setting the System

Manager PIN

Select <Wireless LAN Settings>, and press .

If the <Enable the wireless LAN?> message is displayed, select <Yes>, and press .

Read the message that is displayed, and press .

Select <SSID Settings>, and press .

Select <Select Access Point>, and press .

The machine starts searching for available wireless routers.

If <Cannot find the access point.> is displayed

See

When an Error Message Appears.

Select a wireless LAN router, and press .

Select the router whose SSID matches the one that you have written down.

If your wireless router is not found

Check whether the machine is properly installed and ready to connect to the network.

Installation/Settings Problems

Enter the network key that you have written down.

㻝㻡㻢㻌㻛㻌㻟㻟㻢