Operation Manual

Table Of Contents

0L40-05S

Configuring Ethernet Settings

Ethernet is a standard for communicating data in a local area network (LAN). You can set the communication mode (half-duplex/full-

duplex) and the Ethernet type (10BASE-T/100BASE-TX). In general, the machine can be used without changing the defaults

(

Ethernet Driver Settings), but you can change these settings to suit your network environment.

Press .

Use / to select <Network Settings>, and press .

If a screen for entering a PIN is displayed, enter the PIN with the numeric keys and press . Setting the System

Manager PIN

Select <Ethernet Driver Settings> <Auto Detect>.

Select whether to configure Ethernet settings automatically or manually.

Configuring Ethernet settings automatically

Select <On>, and press . The machine detects and automatically sets the communication mode and the Ethernet type that

can be used.

Configuring Ethernet settings manually

Select <Off>, and press .

Select the communication mode.

Select <Communication Mode>

select <Half Duplex> or <Full Duplex> .

Alternately sends and receives communication data. Select when the machine is connected to a networking device using

half duplex.

Simultaneously sends and receives communication data. Use this setting for most environments.

Select the Ethernet type.

Select <Ethernet Type>

select <10BASE-T> or <100BASE-TX> .

Select <Apply>, and press .

Press .

LINKS

Changing the Maximum Transmission Unit

㻝㻤㻟㻌㻛㻌㻟㻟㻢