Owner's Manual
18
■ BEFORE YOU BEGIN ... ■
Preparing the computer (scanner
mode)
In order to use the Micofilm Scanner 350, your computer must
satisfy the following system requirements:
■ IBM PC/AT-compatible that meats the following specifications:
• Intel Celeron 733MHz or faster
• Main memory: 256 MB or more (recommended)
• Hard disc space: 400 MB or more
■ Recommended SCSI boards
• Adaptec AHA-2930U
• Adaptec AHA-2940AU
• Adaptec ASC-19160
• Adaptec ASC-29160
■ SCSI cable
The SCSI connector on the scanner is a half-pitch 50-pin connec-
tor (pin-type). Check the shape of the connector for the SCSI board
on the computer or the SCSI device to be connected to the com-
puter, and prepare a SCSI cable that is compatible with this unit.
■ Display that is capable of resolution of 1024 x 768 (XGA) or bet-
ter (recommended)
■ One of the following operating systems, running normally:
• Microsoft Windows 95
• Microsoft Windows 98
• Microsoft Windows Me
• Microsoft Windows NT 4.0 Workstation
• Microsoft Windows 2000 Professional
• Microsoft Windows XP
■ ISIS-compatible or TWAIN-compatible application software that
runs normally under your operating system
If your CPU, memory or SCSI board does not meet the
recommended specifications, you may experience
problems such as slow scanning speed.
• Be sure to allocate sufficient virtual memory.
• Depending on the application software that you are
using, the device driver provided may not operate,
or you may not be able to use the functions described
in this guide.
• Make sure that the device driver and application soft-
ware that you will be using are compatible with your
PC, the system configuration, and the type of SCSI
board that you are using.
• The ISIS/TWAIN driver provided with the scanner is
not necessarily compatible with all ISIS-compatible
or TWAIN-compatible application software. For de-
tails, contact your application software dealer.