User`s guide

0
Advanced Operations
Part 4
6
 Inputcharacterdatainaccordancewithconditions.
“Changing character size” ( page 68)
“Changing the spacing between characters” ( page 69)
•
•
7
 Performtheprintingoperation.
Changing segment length of all pages
If “All” is selected on the Seg Length selection display, characters typed exceeding the
specied segment length are deleted. If 2.00 mm is specied as the segment length, all
characters are deleted even when a page containing “6mm 100%” characters exists. For
this page, 2.00 mm is temporarily specied as the segment length and “6mm 100%” is
temporarily specied as the character size and therefore you cannot enter any character.
Select “Automatic” on the Seg Length selection display or change the character size before
entering characters.
It is recommended that you save the le before selecting “All” on the Cut Length selection
display.
Expanding the Plate Printing Area
For the procedure to follow after selecting “Expansion” on the Plate Printing Area selection
display, refer to “Printing with short pitch width” ( page 111).
Adjusting the segment length
You can adjust the set segment length by ±5%.
1.
 Press[Adjust].
The Print Media selection display appears.•
2.
 Press[
▲
]or[
▼
]toselecttheprintmedia,
andthenpress[Enter].
Press [Enter] to display the Adjustments
display.
This segment length adjustment is intended for use with
labels, and may not produce the corresponding effect with
other media.
•
3.
 Press[
▲
]or[
▼
]toselect“Lengthadjust”,
andthenpress[Enter].
The Length adjust selection display appears.•
Character
size
Character
space