User`s guide

08
 Adjustingtheprintingstartpositionandverticalposition
When printing, enviromental factors or characteristics of the print media may cause printing to start slightly
out of position or to be shifted slightly in the vertical direction so that character data is not printed correctly,
even though the correct print media type and size are selected. In such cases, you can shift the printing position
slightly up/down or left/right.
The printing start position can be set independently for each print media.
Case 1
The character alignment is set to “Left” and the margin was set to “3mm”. However, when actually printed, the
margin is only 2mm.
Case 2
Printing is shifted up about 0.5mm.
ex. When printing on label tape (12mm wide), the phenomena described in case 1 and case 2
both occur simultaneously. Make the appropriate adjustments.
1
 Press[Adjust].
The Print Media selection display appears. First, shift the
printing start position 1mm to the right.
•
2
 Press[
▲
]or[
▼
]toselect“Label”,andthenpress[Enter].
This selects the print media for which the adjustment is to be
made.
When [Enter] is pressed, the Adjustments display appears.
•
•
3
 Press[
▲
]or[
▼
]toselect“Leadadjust”,andthenpress
[Enter].
The Lead adjust selection display appears.•
Indicatesthattheprintingstartposition
isatthenormalsetting(withno
adjustment).