User`s guide

37

Maintenance

Part 5

 Replacingatubeorthelabeltapecassette

Remove the tube or label tape cassette as follows, and install a new one.

Contact your dealer if you need to purchase tube or label tape cassettes.

The same procedure as for a label tape cassette applies when using heat shrink tube, wrap around tape and 4mm I.D. strip. Clear tube and plate

is handled in the same way as regular tube.

 Press[Remove]andthen[Enter].

Media is ejected in the opposite direction.

After pressing [Enter], use the feed function if the tube or label is not released from the

transport roller (unable to remove) even after the printer has stopped. (“When a Tube or

Label Tape is Not Ejected/Fed” ( page 128))

•

 Openthecover.

 (Tubeandplateonly)Pullthetubeorplateoutoftheattachment.

Dispose the used tubes and label cassettes according to local government regulation.

 Removethetubeattachmentorlabelcassetefromthemachine.

While pulling the lever to the right, lift and detach the label tape

cassette.

•

 Installthenewtubeorlabeltapecassette.

See “Part 2 Basic Operation” for detail.•