User`s guide
5
Appendices
Part 6
6.5
List of Function
Clear tube reverse
*About the Printing Performed with the Segment Length Specied
The following table summarizes the specications to conform to when printing characters
with “Normal” specified on the
Plate Printing Area selection display and a value less than 8.5 mm specified on the Seg Length selection
display:
Media
Specificationsappliedwhenthe segment length is specified to a value less than 8.5 mm
Plate A segment length can be specied, but only [Centered] can be specied as the character alignment.
Label A segment length can be specied, but only [Centered] can be specied as the character alignment.
* Characters may not be centered when “Half Cut” is set to “On”.
When the label is half cut with the segment length of 3.5mm or less, consider the following:
• Use the 9mm/12mm-width label.
• Cut depth adjustment is required. ( page 130)
Tube
4mm I.D. Strip
Clear tube
Heat shrink tube
Wrap around tape
If you specify a segment length, it is automatically changed to “Automatic” to maintain the print quality
during actual printing.
(The left and right margin become 2.0 mm or wider respectively.)