User`s guide

34
Number of characters that can be input
The printer can accept data input of totalling approximately 2500 characters on all pages
combined; if the printer’s capacity is exceeded, the message “Not enough memory Character
input is no longer possible.” appears. If this occurs, save all text data ( refer to “Saving
character data” on page 86), delete all characters that are displayed on the display (refer to
Memo on the previous page, “Deleting all entered text”), and then continue inputting new
characters.
You can also press [Page] to display the following display, where you can check how much
space is available.
What is a page?
As used in relation to the printer, the term “page” has special meaning. The text entries
“200V”, “Pump Room” and “A1” that were input in the procedure described on page 32 are
actually input on three separate pages. A new page is created automatically whenever you
enter characters and press [Enter].
Viewing data from a previous page
If there is a page preceding the currently displayed page, “
◄
” appears in the upper left
corner of the display. If you press the [
◄
] key and move the cursor to the left past the rst
character that is currently displayed on the display, the display will change to show the
character data from the preceding page. You can also jump directly to the preceding page
by pressing [Shift] + [
◄
].
If there is a page that following the currently displayed page, “
►
” appears in the upper right
corner of the display. If you press the [
►
] key and move the cursor to the right past the
last character that is currently displayed on the display, the display will change to show the
character data from the next page. You can also jump directly to the next page by pressing
[Shift] + [
►
].
Indicatesthatthereisapage
precedingthecurrentpage.
Indicatesthatthereisapage
followingthecurrentpage.
Currently used capacity Free capacity