User`s guide

46
Inputcharacters
ex. create three pieces of wrap-around tape of the following types.
1
 Input“A-”.
Print
Once the characters have been input, begin printing.
1
 Press[Print].
The print media selection display appears.
“No ribbon cassette” is displayed if the ribbon cassette is not installed. Install the
ribbon cassette.
“No ribbon information. No ribbon amount displayed. Press enter” is displayed if
the information cannot be read due to the ribbon cassette failure and so forth. If this
message is displayed, follow the instruction on the screen.
Whatis“printmedia”?
Print media is the material that you are printing on, such as a tube, heat shrink tube,
label tape, wrap around tape, 4mm I.D. strip, plate, or clear tube.
•
Acheckmark isdisplayednexttothe
currentlyselectedprintmedia.
2
 Press[
▲
]or[
▼
]toselect“Wraparound”,andpress[Enter].
The sets to print and range setting display appears.
If “Range: all” is not selected, press [▲] or [▼] to select “Range”, and then press [◄]
or [►] to select “All”.
Rough amount of the remaining ink ribbon is displayed as shown. When the
information of the cassette is not properly retrieved, the amount of the ribbon does not
appear.
•
Makesurethat“Range:All”isdisplayed.
3
 Press[3]andthen[Enter].
Three pieces are printed.
Cancelingprinting
If you press [Canc], the message “Aborting print” appears and printing is aborted. In
this case, the tape that is currently being printed is cut and then ejected.
•
4
 Takeoutthewraparoundtape.
A half-cut tape is ejected.
Iftapejams
Hold down [Cancel] until the printer beeps. The printer stops all
operations immediately. In this case, the tape is not cut and it is
not ejected. Refer to “If a Tube or Label Tape Becomes Jammed”
( page 124) and take out the jammed tape.
•
Thetapeishalf-cut
sothatitcanbeeasily
separatedbyhand.