User`s guide

47
Basic Operations
Part 2
Attaching the wrap-around tape
1.
 Peeltheprintedfilmfromthewraparoundtapebacking.
When wrapping, the laminating cover should overlap the printed part sufciently. We
therefore recommend using with cable of
φ
3 to
φ
7.6 mm.
2.
 Attachthetapetothecableasshowninthediagram,
startingfromtheprintedend.
3.
 Wrapthetransparentlaminatingportionsothatitcovers
theprintedpart.
If the film does not peel away from the backing
Because wrap around tape has a strong adhesive, it may be hard to peel the lm off the
backing. Refer to the following diagram for the peeling method.
Peel-offFilm
PrintableArea
Holdthebacking
Peeltheprintedpartaway
If the cut is too shallow
Wrap around tape is thicker than typical label tape, so the half-cut may be shallower.
In this case, refer to “What To Do If the Cutter Is Getting Blunt” on page 130 to adjust
cutting depth. If it still does not cut, replace with new cutter. ( page 133)
If the half-cut is too shallow, the lm may not peel from the backing properly.
Iftheremainingpartcannotbeseparated,
adjustthecuttingdepth.
PrintableArea
Ifthispartisjoined,pullapart
withyourfingers
Nisca Corporation shall not be responsible for damages that might result from
the tape peeling off, or from fading of the printing on the tape.