Operation Manual

Access refusal:
Selecting Enable will disable searching of this machine by a Bluetooth compatible device.
Security:
When you select Enable, the passkey set on the Passkey screen becomes effective. Setting
the passkey prevents unwanted access from other Bluetooth devices. You can choose either
of the security modes below.
Mode 3 (recommend)
This mode is activated on link level enforced security.
The passkey will be required when a Bluetooth device communicates with the
machine.
Normally select this mode.
Mode 2
This mode is activated on service level enforced security.
The passkey will be required when printing through Bluetooth communication.
A
fter setting the security mode, we recommend making a trial print through Bluetooth
communication.
If printing does not start, change the security mode and try again.
Passkey
Changes the passkey. The passkey is a four-digit number used to prevent unwanted access
from other Bluetooth devices.
The initial value is 0000.
A
fter you change the passkey, you may be required to input the new passkey on a Bluetoot
h
device, even though it had previous access to the machine. In this case, enter the new
passkey on the device.
PictBridge settings
You can change the print settings when printing from a PictBridge compliant device.
Set the print settings to Default on the PictBridge compliant device when you want to print
according to the settings on the machine.
See Settings on a PictBridge Compliant Device
to change print settings from the PictBridge
compliant device.
1.
Select the page size, when printing directly from a PictBridge compliant device.
When you perform PictBridge settings from the machine, set Paper size to Default on the
PictBridge compliant device.
2.
Select the media type, when printing directly from a PictBridge compliant device.
When you perform PictBridge settings from the machine, set Paper type to Default on the
PictBridge compliant device.
3.
Select the print quality, when printing directly from a PictBridge compliant device.
4.
Select bordered or borderless print.
When you perform PictBridge settings from the machine, set Layout to Default on the
PictBridge compliant device.
5.
Photo optimizer
A
utomatically optimizes the brightness and tone of a photo.
6.
Red-Eye correction
Page 569 of 681 pagesChanging the Machine Settings on the LCD