Step 1: Unpack the F30 MFP 1. Carefully remove all items from the box. Step 2: Set up the F30 MFP 1. Remove shipping tape and protective shipping materials.
. Open the scanning unit by pressing the Open button. Remove the shipping material. 3. Unlock the scanner. • • Set the scanning lock to unlock. Press the scanning unit closed until it clicks. 4.
Step 3: Prepare the F30 MFP 1. Connect the power cord and plug it into a socket. 2. If the F30 MFP does not power up when plugged in, press the ON/OFF button to turn it on. 3. Open the scanning unit again. The printhead holder will move to the center position. IMPORTANT: Remove the tape on the printhead holder lever. Step 4: Install the Printhead 1. Remove the printhead from its package.
2. Turn the printhead over, then remove the orange protective cap. NOTE: Do not touch the electrical contacts. 3. Raise the gray lock lever. 4. Gently slide the printhead into the holder. The printhead will rest at a slight angle. Do not press it down. 5. Lower the lock lever and gently press it down until it locks into place.
Step 5: Install the Ink Tanks 1. Pull the orange tab off the yellow ink tank (BCI-3eY), then remove and discard the plastic wrapper. 2. Twist off and discard the orange protective cap. NOTE: To avoid spilling ink, never press on the sides of the ink tank. 3. Insert the ink tank into the correct slot (refer to the color guide on the printhead). Press down gently until the ink tank locks into place. 4. Insert the remaining three ink tanks into their assigned slots. 5.
2. Once the printhead has been installed ALIGN PRINTHEAD/PRESS SET KEY will display on the LCD panel. Press the key once. 3. The F30 MFP will print a vertical line pattern, and the LCD message will change to:. 4. Review the vertical pattern printout, noting which box in Column A prints with the most solid image. For the A Column printed pattern, use the in the column.
. Review the lateral pattern printout, noting which solid box in Column G on the printout has the most solid image. For the G column printed pattern, use the box in the column. keys to scroll to the value with the most solid NOTE: If you have difficulty on Column G when choosing between two patterns, use the smaller value number. Press to select. 8. Repeat Step 7 for Column H on the printout. 9. When printhead alignment is complete, the F30 MFP will return to standby mode.
4. When the main menu appears, click Install MultiPASS Suite. 5. Read the Welcome screen, then click Next. 6. Read the License Agreement. If you agree to its terms, click YES. If you do not agree, click NO. You will not be allowed to continue the installation process. 7. Select the MultiPASS F30 for installation. Continue to follow the on-screen instructions. 8.
. Continue to follow on-screen instructions to complete the installation process. 10. When installation is complete, you will need to restart your PC before using the MultiPASS Suite software. If your PC does not restart automatically, restart it manually. NOTE: Remember to register your product to ensure product support. The serial number is located on the back of the F30 MFP, above the parallel port. Step 7: Install the Software (Parallel cable only) NOTE: Windows 95, 98, Me, NT 4.
Click CANCEL if you see a screen that says "New Hardware Found," "Update Device Driver Wizard" or "Add New Hardware Wizard." 4. Insert the MultiPASS Suite Software CD-ROM into the CD-ROM drive. The setup program should run automatically. NOTE: If the setup program does not run, click START, then RUN, then type D:\csplash.exe, where D is your CD-ROM drive. 5. When the main menu appears, click Install MultiPASS Suite. 6. Read the Welcome screen, then click NEXT. 7. Read the License Agreement.