Set-Up Sheet READ THIS SHEET FIRST Thank you for purchasing the Canon MultiPASS MP700. To get your machine ready for use, please follow the instructions in this Set-Up Sheet before referring to any other documentation. IMPORTANT • DO NOT assemble the machine or connect the USB cable before installing the software. You will be instructed when to assemble and connect the cable. Unpack the machine and its components.
NOTE • When installing the software in Windows 2000/XP, you must log on as Administrator or have Administrator privileges. • If you have previously installed an earlier version of the MultiPASS Suite software (version 4.4 or earlier), you must uninstall it before installing this version. For details on uninstalling the software, refer to the documentation of the previous version. Install the software. 1 2 3 4 Turn on your computer. On your computer, quit any open applications, including virus checkers.
7 In the [MP Setup] screen, click [Install MP Toolbox]. • If you had to restart your computer and Set-up screen is not displayed or you have closed it, on the Windows desktop, double-click [My Computer] (Windows XP: Click [Start], then click [My Computer]). Open the CD-ROM icon, then double-click [setup (setup.exe)]. 8 Follow the on-screen instructions. 9 Click [Finish]. IMPORTANT • Proceed to step below to assemble the machine. Please keep your computer powered on.
Connect the power cord. IMPORTANT • Before turning on the power, make sure the document cover A is closed. A PLEASE WAIT ON/OFF(1sec.) Approx. 30 seconds PUT IN CARTRIDGE 1 Plug the power 2 When you connect cord into a socket. the machine, the Alarm light blinks, and the messages above should appear in the LCD. 3 If nothing appears in the LCD, press [ON/OFF (1 sec.)] to turn on the machine. • If you need to turn off the machine, press [ON/OFF (1 sec.)] for one second. Load paper.
Install the printhead. 1 Press [Open] q and lift up the scanning unit w. IMPORTANT • Do not touch the metal rod or any parts inside the machine. • The machine must be turned on when opening the scanning unit. w q 2 Remove the printhead from its packaging, then remove the orange protective cap A. A B IMPORTANT • Do not touch the electrical contacts B. 3 Raise the lock lever C, then gently slide the printhead into the holder. Lower the lock lever.
Install the ink tanks. 1 Start with the yellow ink tank. Pull the orange tape in the direction of the arrow and remove the plastic wrapper so you can see the air hole A. Turn the ink tank over so that the protective cap B is facing up. Then hold the ink tank as shown below and remove the protective cap B. B M ad e in Ja pa PU n SU Ye lo w In BC k T I-3 ank eY LL U P LL U P A NOTE • To avoid spilling ink, never press on the long sides of the ink tank C.
The machine will print a horizontal pattern, and the LCD will display: CHANGE H VALUE A 0 Column A Value for column A 2 In column A on the printout, note the value of the box with the most solid image. Then use [2] or [3] on the operation panel to select that value. Then press [Set]. BAD SAMPLE Least solid box GOOD SAMPLE Most solid box 3 Repeat step 2 for columns B to K. 4 When values for all columns have been entered and the LCD displays the following, press [#] to return to standby mode. PRINT VERT.
● Install Utility Software To install the Utility Software, in the [MP Setup] screen, click [Install Utility Software]. You can choose not to install the Utility Software at this stage and install it later. For details, refer to p. IV of the Quick Reference Guide. ● View User’s Manual To read the manual on the CD-ROM, click [View User’s Manual] on the [MP Setup] screen. CAUTION • For Windows 2000, the machine may not be able to be set as the default printer.
