Instruction manual

81
E
Editing
Use the wireless controller when dubbing audio.
Do not connect/disconnect any cables to/from the camera when dubbing audio or
preparing to dub audio.
1. Locate the point where you want to start audio dubbing, then press
the PAUSE button.
• You can use the playback buttons on the body of the camera or the special
playback functions on the wireless controller in the same way as in playback
mode.
• The camera becomes set to playback pause mode.
2. Press AUDIO DUB.
• AUDIO DUB. and appear on the display.
3. Press the PAUSE button.
• Audio dubbing starts.
• Direct your voice into the microphone.
• changes to .
4. When you get to the point where you want to stop dubbing, press
the STOP button.
• Audio dubbing stops and AUDIO DUB. disappears from the display.
• The camera returns to stop mode.
• You can also set zero set memory ( 72) at the place you want to stop
audio dubbing, then every time you return to that position, audio dubbing
will cancel.
• If instead of pressing STOP you press PAUSE, the camera will return to the
playback pause mode.
C
A
M
E
R
A
CAMERA
OFFOFF
VCR
P
O
W
E
R
POWER
REW
PLAY
FF
SEARCH
SELECT
ZERO SET
MEMORY
AUDIO
DUB.
STOP
PAUSE SLOW
+ /
– /
×2
Preparations
Turn the camera’s POWER switch to PLAY (MV300i: VCR) and load a recorded
cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed
position).
Dubbing
#4_MV300/MV300i_E(73-84) 3/13/00 15:03 Page 81 (1,1)